PDA

View Full Version : PHOENIX WHEEL COVER NUT, EMBLEM & GENERATOR ACCESS DOOR


poordevil
07-04-2008, 04:57 PM
I have a 99 8365 SVB Diesel with 22.5 " wheels, and chrome Phoenix wheel covers. I lost a chrome Cap that goes over the rear wheel nut. I also need the Phoenix Emblem that goes on the front Wheel cover. Am also looking for 2 rubber catches, approximately 4" long that hold the front hood upper access door open when unlocked. If someone has any information, or needs pictures, please e-mail me @ jfelty2344@aol.com and I will send you the pictures I have taken. Don't know if I can post the pictures here. I tried but had no luck.

quikduk
08-27-2008, 03:38 PM
Sorry for the late reply but I just read the message. I am much more active on the IRV2 forum.

http://irv2.infopop.cc/eve/forums

I have the 1998 version of your GS-DP and those rubber straps can be purchased at either HD truck supply stores or possibly truck stops. They are used for holding hoods and other compartment covers down. I replaced mine and they were around $9 for the pair. Buyers Products makes them. They are called ?hood catches? and I believe you need the 4? long one shown below.

http://www.buyersproducts.com/Truck-Tra ... h-Bracket/ (http://www.buyersproducts.com/Truck-Trailer-Hardware/Hood-Catches/Easy-Grip-Rubber-Hood-Catch-with-Bracket/)

Re: the Phoenix wheel covers and emblems, try the manufacturer here:

http://www.phoenixusa.com/

If you need any more help with your coach, just PM me.