PDA

View Full Version : slide out fullwall


malou
03-15-2011, 12:49 PM
Hi ,my problem is on crenscendo2008 model40UL
Full wall slide out wont retact because of the hydraulic switch is part of the coach wiring. It may be a safety switch that may not allow the room to operate in certain scenarios my case. Looking to find out where the hydraulic switch is located.
That wire is in a relay close to 140-1233 control (diagram 3010000062Rev... page10)


Thank you.

dixieray53
03-15-2011, 06:22 PM
The slides has a safety switch on the drivers seat. The seat must be fully forward. There could be a loose wire on the seat switch. Good Luck...D 8)

malou
03-15-2011, 06:35 PM
So that switch would be call hydraulic switch?
Thanks

malou
04-16-2011, 08:24 AM
Well finaly slove the problem it was 1
wire cut in the wall + control switch .
Lots of trouble for a motorhome that has only a few miles <!!!!!!
power inverter charger
power jack
hawning
water from roof
Hope fully there all fixe. :?

RayChez1
04-16-2011, 03:24 PM
Welcome to RVing. :mrgreen: