03heritagerider
12-14-2011, 07:32 AM
I did a battery equalization last night. I shut off all the systems by throwing the main switch. All 12v power was off. I hit the buttons to start the equalization (pressing the setup and charge buttons at the same time) and the "AC in Fault Overtemp" light came on. I assume that is the indicator that the equalization is in progress.
This morning, I went out and checked the panel, and the "AC in Fault Overtemp" was still on. I pulled the shore power plug, unplugged the phone-type plugs on the inverter and then re-connected it all.
The charge light is on, indicating it is charging. However, the "AC in Fault Overtemp" is still on. Should it be on?
I did not turn on any 12 power, just to be safe.
Also posted in Class A forum.
This morning, I went out and checked the panel, and the "AC in Fault Overtemp" was still on. I pulled the shore power plug, unplugged the phone-type plugs on the inverter and then re-connected it all.
The charge light is on, indicating it is charging. However, the "AC in Fault Overtemp" is still on. Should it be on?
I did not turn on any 12 power, just to be safe.
Also posted in Class A forum.