Gulf Stream Owners RV Forum

		Gulf Stream Owners RV Forum > Search Forums
Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Doug56

Forum: Class A

11-19-2014, 05:01 AM

Replies: 10

Rear Electric Slideout Slow

Views: 10,006

Posted By Doug56

Re: Rear Electric Slideout Slow

:D I found the problems to be a combination of a couple of things. The switch that operates the electric motor takes the full current for the motor. I expected to find a relay to do this job but that...

Forum: Class A

11-14-2014, 05:36 AM

Replies: 10

Rear Electric Slideout Slow

Views: 10,006

Posted By Doug56

Re: Rear Electric Slideout Slow

I have been troubleshooting this problem and found that it is electrical. All the roller are working and there is no binding going on. The voltage at the motor drops significantly when operated. I...

Forum: Class A

10-27-2014, 05:32 PM

Replies: 10

Rear Electric Slideout Slow

Views: 10,006

Posted By Doug56

Rear Electric Slideout Slow

My 2004 Crescendo electric rear slide-out is very slow and sluggish. I have lubricated (dry lube) all the rollers, hinges and screw but still need to assist with a slight push when the slide is being...

Forum: Class A

10-18-2014, 05:59 AM

Replies: 3

Front furnace

Views: 4,302

Posted By Doug56

Re: Front furnace

I'm sorry I was not clear. The cover I was referring to is on the outside of the MH where the front furnace is located. My front furnace is on the passenger side about halfway back. I found a micro...

Forum: Class A

10-17-2014, 05:31 PM

Replies: 3

Front furnace

Views: 4,302

Posted By Doug56

Re: Front furnace

I have found that there are micro switches on the unit that sometimes hang up. Take the outside cover off and inspect those switches.

Forum: Class A

06-10-2014, 07:13 PM

Replies: 0

Access to diesel from rear of coach

Views: 3,393

Posted By Doug56

Access to diesel from rear of coach

:? I have a 2004 Crescendo with a Cat 3126E diesel. I am not certain if I can remove to rubber shroud around the radiator to get access to replace the belts. I have done some engine work by...

Showing results 1 to 6 of 6

All times are GMT -5. The time now is 05:09 AM.