Thread: Engine Access
View Single Post
Old 08-18-2007, 08:24 PM   #7
GStream40
Site Team
 
Join Date: Nov 2005
Posts: 895
Default

On our rear pusher 4 slide coach I must do the following to access the engine from inside:

1) Run both bedroom slides in the out position.

2) Remove the mattress from the bed and stand on it's side edge at the rear of the coach in front of the rear closet. Raise and support the aluminum frame for the mattress. (I made supports from wood for this purpose)

3) Remove the screws that are located at the foot of the frame that hold the cedar chest cross frame and seat in position. Remove the cedar chest liner that just sits in position.

4) Remove the screws that hold the covers over the engine and pull both covers up and there is the engine!!

That is the procedure that I had to figure out for myself, no help from dealer nor Gulf Stream, but in all honesty, I never asked either. It just looked self explanatory to me.

Ron
__________________
2004 40' Yellowstone Quattro 8408YSB Diesel
Pusher Kitty Kat Powered 350hp C7 w/full body paint, Freightliner XC Chassis
GStream40 is offline   Reply With Quote