Gulf Stream Owners RV Forum - View Single Post - Engine Access to 2004 Sun Voyager 8378 Workhorse Engine Comp

bmojmhs · 07-12-2016, 07:45 PM

I have a 2005 Ultra Supreme with a Workhorse chassis.

My dog house is cracked and I have to remove so I can fibreglass the inside. I was looking at it today and so far have found 3 screws that hold it down. Where it attaches to the section under the dash, the top right and left have a screw and I found one about the edge of middle of the flat section. I don't know how many screws there should be but have read others saying the are about 8 being there(?).

For easy access you may have to remove the seats. Still trying to find out what type of gasket was used on it.

I have jacks on mine and can lift the front end of the ground. Doing that, it looks like there is enough room to change the plugs without removing the dog house. I did that to replace the dash air compressor and the fan belt.

Maybe someone else can give further info on the number of screws and the gasket you need if you remove it.

07-12-2016, 07:45 PM	#2
bmojmhs Member Join Date: Jul 2016 Location: Vancouver Posts: 66	Re: Engine Access to 2004 Sun Voyager 8378 Workhorse Engine I have a 2005 Ultra Supreme with a Workhorse chassis. My dog house is cracked and I have to remove so I can fibreglass the inside. I was looking at it today and so far have found 3 screws that hold it down. Where it attaches to the section under the dash, the top right and left have a screw and I found one about the edge of middle of the flat section. I don't know how many screws there should be but have read others saying the are about 8 being there(?). For easy access you may have to remove the seats. Still trying to find out what type of gasket was used on it. I have jacks on mine and can lift the front end of the ground. Doing that, it looks like there is enough room to change the plugs without removing the dog house. I did that to replace the dash air compressor and the fan belt. Maybe someone else can give further info on the number of screws and the gasket you need if you remove it.