My 2000w F 458 died. No ac out. You Tubo videos
Showed how to setup start and run...
Hold setup till leds change, press invert
To move lighted led to lowest one, then
Plug in a 40w or more light bulb. The load sensor
Should see a need for power and come on.
Mine just charges batteries. The temp sensor
Has been known to short power into controls
Where it doesn’t belong. Don’t connect to batteries.
Back-feeding of other power may be a problem
I’m told, still checking... Transfer sw. should have
A delay to keep sources separate.
Now working on the xantrex inverter. Charges, but no ac out.
Heat monitor unplugged, to be replaced and mounted away from
Electrical terminals! It’s not to be connected, or may fry inverter, maybe
Batteries if it gets corroded, mounted to the positive post.
My new 2500 will replace the 2000 so I can rebuild the old one.
‘Strange that the new one came with a temp sensor, still on a terminal ring.
Would they sell hip waders, pre-filled with water?
|