I have a 2010 Supernova 6400 and the slide control unit (located in one of the right side storage compartments) requires 12 volts from the ignition to allow the slide to activate. I ended up putting a small AC to 12 VDC converter in the compartment that is powered from one of the AC outlets in the compartment. I wired the 12 volt output from the converter to the slide control unit so if the ignition switch is on or the RV has 120 VAC (shore power or generator) it will allow the slide to work. This makes it very nice when you want to move the slides in/out, but you don't want to climb into the cab and or start the engine.
|