Here's the Recalibration procedure that is for our 2004 Gulfstream Yellowstone with the Power Gear Auto leveling system.
I had to use this procedure one time after we first purchased the coach, after that it was right on level every time.
T.I.P. Troubleshooting Information on Power Gear1217 E. 7 th Street Mishawaka, IN 46544 Phone: 1-800-334-4712 1-888-339-2539 Fax: 574-256-6743 AUTOMATIC LEVELING SYSTEM SET-UP & RECALIBRATION PROCEDURE Note: The following set-up and recalibration procedure is for control 500630 (used with touch pad 500629) Zero Mode: Zero mode is the mode the user must enter in order to reprogram a new zero point. The zero point is the stored level position—the orientation the control sees as level. Zero mode is indicated on the control touch pad by all LEDs flashing. If the control is in this mode already, you can skip the recalibration procedure and move straight to the set-up procedure Recalibration Procedure Follow this procedure to enter zero mode: 1) Turn the ignition on and the touch pad on 2) Push the front button 5 consecutive times followed by the rear button 5 consecutive times within 10 seconds • All of the LEDs on the touch pad will begin flashing. This indicates that you have successfully returned the control box to zero mode Set-Up Procedure Follow this procedure to reprogram a new zero point (stored level position): 1) Place a carpenter’s level on the floor in the center of the coach 2) Manually level the coach: • Push the front button until the jacks contact the ground • Push the rear button until the jacks contact the ground • Push the left and the right button to verify that all of the jacks are on the ground • Using the carpenters level, complete the leveling process manually by pushing the appropriate buttons on the touch pad 3) After it has been verified that the coach is level, the zero point can be set • Push the retract button three consecutive times (the new zero point has now been set) • After the retract button has been pushed three times all of the LEDs on the touch pad will stop blinking except the On/Off LED • The On/Off LED will flash for 20 seconds. This mode is prompting the user to tell the control if the chassis has an air bag suspension system • If the chassis has an air bag suspension system press the RETRACT button again three times within 20 seconds of the time the On/Off LED starts blinking • If the unit does not have an air bag suspension system DO NOT TOUCH ANY BUTTONS within 20 seconds of the time the On/Off LED starts blinking
Ron
|