Re: low point plugs to valves?
I too changed the screw on caps to ball valves, used Flair It fittings. I know the hardest part was removing the PEX clamp but living in small town with locally owned shops the person at hardware store showed me the easiest way. Then he also said to use a hair dryer or heat gun and get PEX warm and you will be surprised how easy they go in. Also while working on plumbing extended drain on fresh water tank to side of trailer, that laying underneath it to open cap was getting old and the water dripping down arm was annoying. By the way did you get to camp and check to see that the valves were not leaking. Glad to report that my change over is not, yay plumbing always leery about
Rob
|