Re: 2008 BT Cruiser 5291 hot water by-pass valve
Look for the location of the hot water heater on the outside of your rig, Then, go inside to see if there is a panel near that location on the insides that can be removed by unscrewing a few screws. In my BT Cruiser 5211, we found that we did not need to remove any panels at all since we could remove the second drawer on the left side under the kitchen sink to access the bypass. Either way, it is a 5 minute job at most.
I would start by removing drawers and using a flashlight to locate the bypass.
Roy
KRoseVideo
|