Hi ,my problem is on crenscendo2008 model40UL
Full wall slide out wont retact because of the hydraulic switch is part of the coach wiring. It may be a safety switch that may not allow the room to operate in certain scenarios my case. Looking to find out where the hydraulic switch is located.
That wire is in a relay close to 140-1233 control (diagram 3010000062Rev... page10)
Well finaly slove the problem it was 1
wire cut in the wall + control switch .
Lots of trouble for a motorhome that has only a few miles <!!!!!!
power inverter charger
power jack
hawning
water from roof
Hope fully there all fixe.