I have removed our Splendide on several ocassions for repairs.
If yours is like our Yellowstone 8408 Quattro, to remove it, I must first remove the bedroom door, remove the two doors on the cabinet where the washer/dryer located, remove the two
doors on the cabinet above the W/D. I also remove the center divider for the top doors, by removing the two top and bottom screws that hold the divider in place. Then remove the bottom/floor of the upper cabinet, the bottom is made in two sections, I always remove both sections to allow easier access to the water hoses, vent hose and electrical plug.
Remove the bottom removable panel on the washer and you should see two screws that hold it in place to the floor/bottom panel.
I have found that you will need two men with strong backs to slide it out and lift it onto the floor. I always place a throw rug upset down on the floor and slide the W/D out into the
livingroom area, much easier than trying to carry it out there. Now carrying out the door is one rough job.
Good Luck, protect your back,
Ron