well, heading out .for last trip tomorrow ,
Hope it doesnt snow too much. have had slide working several times, looks like problem solved. ended up lowering outside of slide wall half inch, this changed angle of floor when sliding out to rub on nylon wear strip, and not on sharp edge of steel. also tightining screws on plate to pull edges down slightly. still not sure how to fix floor, work on that next spring. also caulked edges of floor, this appears to b an issue of floor edges sucking in water and rotting. aluminum siding on slide stops short of edge. Read this on internet posts, floor on mine is particle board, not plywood. Had a drip rail fabricated from white aluminum to put over slide on trailer side, as factory seal doesnt suit me. saw this on a Canyon Trail trailer last trip.fingers crossed.