PDA

View Full Version : 2006 6340 Gulf Stream Endura --- Slide/Jacks questions ?


mailmann
04-06-2008, 04:32 PM
We bought this about a month ago and it's still too cold too take it out and test it. But, I've been going over the books on it and there's nothing on the Slides or the Jacks . I called Gulf Stream and they said they would send me all the info. they have on them. That's been three weeks and haven't got anything. Doe's anybody know who the Manufacter is? I figure I can go to there website or call them. I'm trying to figure out how to put them in manually in case I have trouble with them.

Thanks
Mike

Texas TC
04-06-2008, 05:34 PM
If they are like the SuperNova, they are Power Gear. I got my manual from their website.

http://www.powergearus.com/

mfa
04-06-2008, 06:45 PM
If they are like the 2006 Ultra Super-C, they are Equalizer Systems...
http://www.equalizersystems.com/index.asp

mailmann
04-07-2008, 02:01 PM
Thanks you guys, these two posts should take care of it.
Mike
:D

amman1725
05-17-2008, 08:35 PM
Just a quick note; If your slides start acting flakey it might be the electrical ground; the system is grounded through the mounting bolts for the hydraulic pump; ours came loose a year ago on our 06 Endura and no-one could figure it out till our mechanic bumped into the pump and hey this thing is loose; tightened up the bolts and the slides have worked great ever since!

mfa
05-17-2008, 08:47 PM
Just a quick note; If your slides start acting flakey it might be the electrical ground; the system is grounded through the mounting bolts for the hydraulic pump; ours came loose a year ago on our 06 Endura and no-one could figure it out till our mechanic bumped into the pump and hey this thing is loose; tightened up the bolts and the slides have worked great ever since!

When we are not actively using it, I try to take our MH out of storage every 2-3 weeks and "exercise" it for a bit. Open the slide, run the genset, run the AC, drive ten miles or so, etc. A couple of months ago I did that and the slide would not open. Wouldn't even try to. I didn't have time to work on it that day, so I took it back to storage. The next week I picked it up to work on it and the slide worked perfectly. It's worked every time since then, too. All I can guess is that it was some kind of grounding problem, perhaps as you have noted. I did look at it at the time and noted that some of the wiring was very tight. I did my best to put some slack into it...

Swanee
10-28-2008, 07:01 PM
I'm Having trouble with my 6340 as well. Initially the slide would not retract with human interferance (pull like Hell-o) and it would finally retract.
Took it by Camping world, they lubricated the slides worked like a champ. BUT Now it seems like it's about to fall out on the ground. Let me know if GS sends info that in itself would be noteable.

Mike

mailmann
10-29-2008, 03:30 PM
It has the Equalizer System, I had too have all the o-rings replaced, it was leaking like a siv. They're working ok now but, they make a lot of noise going in and out.
http://www.equalizersystems.com/index.asp

Mike

10-30-2008, 08:44 PM
DELETED

mfa
11-02-2008, 07:00 AM
When we are not actively using it, I try to take our MH out of storage every 2-3 weeks and "exercise" it for a bit. Open the slide, run the genset, run the AC, drive ten miles or so, etc. A couple of months ago I did that and the slide would not open. Wouldn't even try to. I didn't have time to work on it that day, so I took it back to storage. The next week I picked it up to work on it and the slide worked perfectly. It's worked every time since then, too. All I can guess is that it was some kind of grounding problem, perhaps as you have noted. I did look at it at the time and noted that some of the wiring was very tight. I did my best to put some slack into it...

I found out the cause of this last week when it happened again. It turns out there is an interlock with the parking foot brake and the slide will not operate if the parking brake is not set. :oops:

mhogge
04-29-2020, 09:53 AM
Old thread but hoping to get some help? I have an 05 Gulfstream Sunoyager with an Equalizer system and trying to figure out hoe to operate it manually? Any help would be greatly appreciated.

Mike1931
06-27-2021, 03:45 PM
We have a 2004 Endura Gulf Stream.
The manual power button lights up, but nothing
works. When I press any of the leveling buttons, nothing happens.
No motor noises and nothing happens.
Anyone have a clue! Of what to look for. The equalizer
Control panel is now obsolete.
Help!!!!