jberndt
09-03-2013, 04:12 PM
I have a 2008 Tour Master with the 16 foot full wall slide. All of a sudden the front part of the slide will not go out. The back portion goes out a few inches and puts the wall in a bind. So I think it's either the front motor or the shear pin on the front motor but I cannot find the stupid thing! Can anyone tell me where the front slide out motor is located?
Only other piece of information I have is that the water tank fell half way down in the storage area. That was caused by a factory defect. Whoever put the braces in for the tank stripped one of the bolts and caused three of the brackets to pop out. I have the water tank back in correctly but then the slide out just stopped working. The slide out did work two times after I remounted the water tank. The slide out motor is NOT located above the water tank.
HELP please if you can.
Only other piece of information I have is that the water tank fell half way down in the storage area. That was caused by a factory defect. Whoever put the braces in for the tank stripped one of the bolts and caused three of the brackets to pop out. I have the water tank back in correctly but then the slide out just stopped working. The slide out did work two times after I remounted the water tank. The slide out motor is NOT located above the water tank.
HELP please if you can.