Removing a washer/dryer combo from a 2007 Gulfstream Crescendo 8356 crw

[bbybee]

Have never put one in or taken one out but I would think it would be fairly straight forward.

Un plug from power
Turn off water supplies and disconnect
Slide out – any bolts holding it in?
Get it out the door – measured and it fits out.
Cap off water supplies and Velcro to back wall.
Have fun building the shelves to go inside cabinet.

Thought, suggestions & or ideas ???

[bbybee]

Slide out – any bolts holding it in?

Thought, suggestions & or ideas ???

There seems to be something holding the washer combo in (or it is just really stuck to the floor)

I can not find any info if there are any bolts or clips holding it in.

Amy help would be fantastic please.

Thanks,
Buck

[Restorium]

There seems to be something holding the washer combo in (or it is just really stuck to the floor)

I can not find any info if there are any bolts or clips holding it in.

Amy help would be fantastic please.

Thanks,
Buck
Look in the basement compartment below the washdrier and see if there are any bolts coming through the floor. Most thing are bolted through the floor.

[Jim_PEI]

I took one out about six years ago, and there was nothing holding it down. Pretty tight everywhere though.

[bbybee]

I'll look in the basement and yes it is very tight.

Thanks for the info...

Buck

[bbybee]

I got the combo out but there was a plate with 2 screws into the floor at each leg holding it down. Luckily the the back ones I was able to rock and move the legs out of them.

Thanks
Buck

[Jim_PEI]

Good for you. I guess mine was not originally installed properly.

[bbybee]

I think mine was over kill on the install...

Buck