[riverofcode]

I did the same thing for all 3 of my rollers that Chuck did to his slide rollers. I used, as I recall, either 14 or 16 gauge stainless steel sheet that I had the steel place cut for me. It tucks up thru the seal all the way back to the interior trim and screwed with stainless self drilling screws then some tape to protect the rubber from the edges cutting it. Be aware that there are some places there trim has a different profile from what the center is vs the edges and the steel had to be either shorter a bit or the corner clipped. Just checked the email to the steel place and mine were cut at 8" x 22 3/8" but I had to trim one or two of them with a angle grinder when I hit the blocks I didn't see. See attached.