[David Bott]

Hi...(As I had already replied to your PM on June 2nd.)

It sounds to me like that it has shifted down and needs to be adjusted. Even more so if it is hitting the molding. It should be above the molding. More or less what happens is over time is will drift some. It is only bolted on.

So what needs to be done is when the slide it out, that back end of the slide will get jacked just so it is supported. (Usually a 2x4 is used between the jack and the floor of the slide with another 2x4 down to the jack. (Like a T ). Then the two nuts are loosed and it is jacked up a little more. Then the nuts and tightened back down. Move the slide in and check alignment.

I did not tell you the above so you can do it, I would still suggesting having it done. Just wanted to let you know it was not that bad of a process.

The coaches are painted with the slides in place. So if it was aligned correctly at the factory before painting, as they normally are, then the paint should match up.

Take care.