[CraigS]

Just wondering if anyone has any experience repairing Power Gear hydraulics?

I have a 2008 Gulf Stream Independence (Ford F53, 35') with manual Power Gear levelling system. The reservoir is full to (1/4" below top) and both hydraulic slide-outs running off the same pump work fine.

When I turn the key to the run position, all lights flash on the Power Gear control panel. The pump runs for about 5 seconds and then stops. Visually the jacks appear fully retracted. Pressing on/off stops the flashing lights. The system will now stay off until the key is set to run again.

Any thoughts or experience?

Thanks, Craig