View Single Post
Old 09-02-2007, 10:39 PM   #1
Arthur Hayes
Senior Member
 
Join Date: Dec 2006
Location: St. Augustine
Posts: 164
Default Power Gear leveling Jacks

Suddenly my leveling jack panel has started causing me fits. I was all set to leave my site and when I turned on the jacks at the control panel all I got was flashing lights. The manual says this is due to low voltage. Tested the circuits at the panel and all were above minimum. Only way I could go was to release the parking break and let the safety system retract them. The light flashed all day. The next day I removed the panel from the dash and cleaned all the contacts. Thought I had it cured until I started to replace the screws, the light started flashing again. Removed panel from dash and they would stop, and system would work, but as soon as I put it back on the dash the problem would raise its ugly head. Maybe the printed circuit is bad, don't know. Has any one encountered this in the past?
__________________
Art Hayes
2007 Tour Master T40A
Mercedes Engine
Blue OX Tow Bar
Unified Break System
Arthur Hayes is offline   Reply With Quote