View Single Post
Old 04-22-2020, 08:48 AM   #4
Fitz
New Member
 
Join Date: Sep 2019
Posts: 3
Default

I tried replying earlier but apparently did not work. I replaced the conv/microwave in my 2007 BT 5290 and had a lot of trouble. Finally discovered long small diameter bolts going up at an angle-entering a few inches back from the front bottom outer edges-going at an angle up to the bracket mounted on the wall at the top rear of the unit. The bolts screwed into the wall mounting bracket. The bolt head was hex as I recall and only about 1/4" in diameter. My old unit was an Amana radar range. Good luck, Howard
Fitz is offline   Reply With Quote