View Single Post
Old 01-21-2009, 06:55 PM   #4
gbarngrover
New Member
 
Join Date: Jan 2007
Posts: 29
Default

Mine had 3 cables hooked to the booster plate also but were marked antenna, cable & TV. The TV is the one I connected to the converter.
On yours it should be the one marked booster.
If you have a voltmeter take the antenna cable off and stick one probe in the center where the cable was attached and the other probe to ground (on outside touch the threads).
The one going to the antenna will have voltage, I think it is 12 volt.
There shouldn't be any voltage going to the TV.
Hope this helps.
I was suprised the reception has improved a lot with the converter box, I get good reception on channels that were not clear before installing.
gbarngrover is offline   Reply With Quote