[Zapper58]

Decided to look at this yesterday. Extended the slide out almost all the way, jacked it up to take the weight off the front roller. Then decided to take the screws out of the roller bracket and slide it towards the front of the Mh. I used 2 existing holes that were the front of roller and now it is the rear. Drilled a hole from underneath the floor up through the front bracket of the roller accessed through the lower storage compartment. The roller now is about 4" from the end of the slide out. Set the slide out down, and ran it in and out. Wonderful , it is much better , smoother operation, etc. Should have been that way when it was made. At least they could have put in another roller. The slide out is heavy.