The red light means the booster is on. Take the coxial cable off from the new antenna and check for voltage on the cable between the single wire in the center of the coxial cable and the outside metal mesh or the nut.
You should get a voltage reading around 12 volt.
If no reading there the booster might be bad, on the back side of the booster take of the cable that goes to the antenna and check for voltage from the center where the single wire goes in, to the metal outside where the nut screws on, should be about 12 volt.
There should be some troubleshooting on the manfacture web site, I am not sure of the exact voltage, mine is 12 volt but is not Wingard
|