View Single Post
Old 02-28-2021, 12:56 PM   #2
MAJWayne88
Member
 
Join Date: Aug 2020
Posts: 48
Default

Quote:
Originally Posted by Rvfamily View Post
Hi all, I'm replacing some rotted flooring in the middle of my RV in front of the kitchen and slide area. When I removed the flooring I see the support beams are like a 1 X 2 made of metal. It's weird to me the flooring is only glued on without any screws. It's about a 6 foot by 6 foot section I'm replacing so can I glue and put screws through the wood into the metal supports? I wasn't sure if there are wires or hoses in the cavity of these beams. Has anyone done this before? Thanks Ron
Yes sir, I just recently replaced the flooring in my 36 foot, Class A. There were places I had to add cross beams (1x2 rectangular metal) and replaced all 8ft x 16ft midsection of sub-floor and flooring. It turned out pretty nice, but now is the fun part of putting it all back together. I did not use glue, however, I did screw it down with self-tapping screws (#10, 2 inch). Hope this helps!
MAJWayne88 is offline   Reply With Quote