Thread: New RVer
View Single Post
Old 05-29-2022, 01:20 PM   #5
Papa Dave O
New Member
 
Join Date: May 2022
Location: East Tawas
Posts: 5
Default

I’m almost certain my was damaged when the original owner was driving with the step down. The step supports have been welded and the motor (with model number) is missing. I fully leered the step and drilled a hole in the support brackets. Now when I extend the steps I put a Clovis been thru the brackets and it secures the steps down . I pull the pin and bungee the steps up. I may drill another hole for a pin in the up position but I am not going to spend $700 for a new step and motor assembly. Eventually I will probable buy a manual step. Thanks for your reply.
Papa Dave O is offline   Reply With Quote