Wondering if the rest of you may you double check your Tourmaster to see if the graphics on your slides and coach match up perfectly?
This past weekend I noticed that the exterior molding piece right under my main slide is loose (I will epoxy it back next week). Then I noticed that the graphics on my main slide and coach do not match up perfectly, the lines on the aft-side of the slide are half-inch lower than the ones on the coach. As if the aft-side of the main slide has dropped a little and pushed the molding below loose.
However, without looking at the graphics, the slide seems level with the molding and does not leak. So maybe it is just the graphics and not the slide? Wondering if I should get the main slide adjusted-lifted so that the graphics match, at the risk of it leaking, or just accept the slightly-off graphic lines? Let me know what you think.
Below are 3 pictures:
Below is a picture of the graphics not lining up on the slide and coach
Below is a picture of the bottom edge of the main slide appearing to be lined up with the bottom molding
Below is a picture of the molding coming loose.
