Here is a case in point.
These two images are of the driver side right by the hot water tank. It is the last part of the molding on that side coming up from the back.
The molding is UP 1/4" vs the middle of the molding and the panel below it does not even fit the coach! According to the repair center I have it at, it is short almost 1/2" under the molding as the panel was not made right. When the molding was put on, it was not put on level which exposed the issue.
IT WAS EVEN PAINTED LIKE THIS!!!!! No one, but on one, said, "hey, this is not right."
And no, the molding did not just move up. It is attached like this and even sealed in place. If you look, if you move the molding down to hide the whole, the paint would no longer line up. (Thus the mention about it even being plaited like this.)