View Single Post
Old 04-13-2007, 01:02 AM   #1
djqualls
Senior Member
 
Join Date: Aug 2006
Location: Tecumseh
Posts: 175
Default Removing/Modifying Driver Seat

Hello All,

I want to pull the driver seat to do some wiring cleanup and re-route some cabling under the dash. But It is too tight to work around. I looked under the coach and saw the four bolts protruding through the floor and are attached by nuts that are attached to the frame so it should be straight forward. Just pull the 4 bolts and disconnect the power seat cables.

I would also like to build a spacer plate to raise the seat height a couple of inches because the seat sits too low and on long drives, I begin to feel like my knees are under my chin. I am only 6'3 but this seat while very soft is too low for my knees and hips to take a long drive without being sore for a day.

Has anyone done any of these tasks?

Any advice is greatly appreceiated.

Thanks

Dave.........
__________________
2006 TourMaster T-36 / Good Sams / FMCA 380624
djqualls is offline   Reply With Quote