Re: Washer Fluid problem
Well, I didn't have to replace the whole thing. I removed the reservoir and pump. I removed the pump and the fluid from the reservoir and when I poured the fluid out a black grommet came out of the reservoir too. I believe this grommet had lodged in the suction of the pump. When I tested the pump in a dish of fluid it worked fine. I put everything back together and tested it again and all was well. One thing, when I hooked up the electric to the pump, I found out, you have to make sure you have the hot wire on the positive pole of the pump.
__________________
Don & Carol Niemeyer & Sandy
2006 Gulf Stream Tour Master
2011 Equinox LT1 Toad
|