I have a 2007 BT Cruiser. #5230. I need to find out where is the drainage plug for a suburban sw6d water heater. Is it underneath the rig? If so I cannot see it looking underneath from outside. I have to change the rod. It looks very corroded from the outside. I have not changed it in the 4 yrs I have had it. Don't know when it was last done. thanks
I have a 2007 BT Cruiser. #5230. I need to find out where is the drainage plug for a suburban sw6d water heater. Is it underneath the rig? If so I cannot see it looking underneath from outside. I have to change the rod. It looks very corroded from the outside. I have not changed it in the 4 yrs I have had it. Don't know when it was last done. thanks
My drain plug is 1 1/16”, I use a 6 pt socket, 3” extension to remove and gently tighten. I also use Teflon tape on the threads to seal them.
__________________ John The sheep always complain about the Sheepdogs UNTIL the Wolves show up then they beg for help!
The drain plug is the rod. Be sure the WH is off, cool, and not under water pressure. An oddball 1 1/16 inch socket fits over the end. There is also available a cheap $4 plastic rinse nozzle that fits on the end of a garden hose to help flush out the crud from the bottom of the tank.
[QUOTE=bigal;31143]I have a 2007 BT Cruiser. #5230. I need to find out where is the drainage plug for a suburban sw6d water heater. Is it underneath