Slide doesn’t work

[BBCamaro]

Hi all
I have a 2005 Gulf Stream endura 32 ft the slide won’t do anything. Any info will help . Thanks

[Bike Dr]

Hello, I am assuming the slide is hydraulic, if so check the fuses first and if the fuses are okay. on most pumps at the rear of the pump or close should be a rest button! If the reset and fuses are all good next locate the power wires to the pump and apply power from the battery directly to the motor to make sure the pump is good, these are quick simple things that will let you know what else if anything needs to be tested further like relays and such!! Please let me know if this helped!

[BBCamaro]

I have the equalizer system the jacks work but the slide won’t do anything

[Bike Dr]

Hello again, okay if both systems run off one pump, you will have to by pass the slide switch to eliminate the switch as the culprit, or a switching solenoid down by the pump, I know this is a dumb question but does your rv have a safety? Mine has one under the drivers seat and is a class a, but my slides technically won't move unless the seat is in the far forward position, I'm just saying something like that will affect operation of the slide!

[BBCamaro]

Ok thanks , how do I bypass the switch? I have what I believe is a uni directional motor. I’m new to the slides.. thanks again

[Bike Dr]

Screenshot_20220207-190012_Drive.jpg

Screenshot_20220207-185953_Drive.jpg

Hey I attached wiring information and a guide that my be helpful. Good luck!

[BBCamaro]

Thanks! I did find out that the slide will move when I am operating the jacks so now . There is no power at the switch so now I’m looking for the source of power to the switch.. thanks again