Tail light replacement 2006 Independence

[Canyon92587]

Multifunction tail light brake/turn signal not working. The parking light does work. I pulled out the unit which is labeled "Glo-Brite 9551". This is a sealed assembly. I tried to research it but apparently it has not been available for several years.

Has anyone come up with a solution for this?
Thanks for any help...................Jim

[beachrunner]

I have the same issue. Same GS Independence 2007. Does yours have the rubber seals around the lens. How did you get the wiring out of the lite housing/lens? Does it unsnap or pull down or pry off? lets hope someone replys,

[Canyon92587]

You press in on an edge of the lens until it goes sideways, then you can pull it out.


It took a lot of silicone spray to get it to go back in.


You will find it is a closed assembly and I do not know what is inside.
If mine fails completely, I will take a Dremel and open it up.