BT cruiser full rebuild

[❤️life]

I too had a gap on passenger side cab to coach connection below gutter drain and am trying to replace screws outside many break off at head so thought if I could get a knowledgeable individual of what you have replaced outside screws with? also my paint looks the same as yours do you have any information on how to get those different colored screws

[Just two]

The bed systems works great. 2 - 6” twin beds. We cut 10” off the width this we used to make 3 - 24” bolsters. The beds pull out to 37” or we can used them at 26”. Nice to have choices. We took it out for a shack down cruise.

I added 2 stabilizers on the rear. Found a neat trick to help level the rear. I used the onboard compressor to raise the rear then brought it down to the stabilizers at different heights to get it level. Worked good. I since added valves to adjust each side independently.

[Just two]

Originally Posted by ❤️life

I too had a gap on passenger side cab to coach connection below gutter drain and am trying to replace screws outside many break off at head so thought if I could get a knowledgeable individual of what you have replaced outside screws with? also my paint looks the same as yours do you have any information on how to get those different colored screws

I was able to reuse the screws that I removed. I broke one when I used a drill driver to reinstall it. After that I only used a square head screw driver. I didn’t break any more. We found some spray paint that was very close in color. Poked the screws in cardboard and sprayed the heads. Good to go.

If you need the color codes for bigger sections you should contact GS. They will need your rigs info. Good luck.