No Power to slide.

[Tim 6316]

2006 Class C Conquest 6316. Also noticed no power to light in the compartment which has the slide motor. Side went out 2 inches, then stopped. I suspect it's a fuse, but can't find it. Main panel fuses are fine, fuses/breakers in battery compartment are fine. Even changed the slide switch. Must be a fuse somewhere. Any ideas ladies and gentlemen? FYI, its electric motor (I replaced in 2019), emerg brake is on, seat is forward, and engine is off.

 

[Lchristler]

Try looking for a small relay wired inline in the battery compartment with the hydraulic slide and jack motor.
Mine was wrapped with electrical tape. The terminals were badly corroded. It is hot when the parking brake is set. Now we only use parking brake to use slide, then release it.
Hope this helps.

 

[THenne1713]

The 12VDC CIRCUIT BREAKERS are usually next to battery, or within 18". Mine are under step beside battery/ battery switch. On mine, DEWALD hydraulic, FORWARD/REVERSE SOLENDOIDS were sticking engaged after switch released, and would trip the breaker. Repalcing solenoids and breaker cured my issue. Good Luclk